Oil discharge steps of Shijiazhuang slurry pump

I believe everyone knows something about slurry pumps. During use, you may need to drain oil. The following steps are introduced: 1. If you want to drain all the oil in the oil tank of the slurry pump, you can unscrew the oil drain plug at the bottom of the oil tank to drain the oil. 2. When the slurry pump discharges oil outward, the liquid level shall not exceed 30mm from the top plate of the oil tank to ensure the lubrication and cooling of the bearings in the pump. When the volume of the working chamber of the jack is too large, it is necessary to install an oil tank to ensure that the liquid level is very low and the height is not less than 100mm after oil discharge, so as to avoid inhalation. 3. After the variable speed slurry pump starts running for 500 hours, change the oil and clean the oil tank and oil filter. The quality of oil shall be tested by visual inspection and laboratory test. When the oil quality deteriorates, change the oil in time and clean the oil at the same time. If there are metal chips or water in the oil tank and oil filter, find the cause and troubleshoot. 4. In a short time when the liquid level drops, the bearing is lubricated by the attached oil and splash oil of plunger spring. Oil tank oil filter and oil filter under pump are made of 230 mesh/inch copper wire mesh. Oil filter should be cleaned regularly to prevent blockage. The oil temperature in the oil tank shall not exceed 60℃ during use. Take appropriate measures to cool down when necessary. Some people may not understand the oil discharge of this slurry pump, so it is necessary to know the above related contents. And is beneficial to the operation of the slurry pump during use. It will be very convenient to operate and bring more help. Hebei Yingdike Pump Industry Group Co., Ltd. is a professional manufacturer of slurry pumps, submersible slurry pumps and sand suction pumps. It is an enterprise integrating research, development and production in Hebei Province.